smokey_spunk's Question:
i have a PSE fire flight compound bow, 70lb, 31 inch draw length and I want to know how to take down the punds properly


dumdum's Answer

Where the limbs are attached to the riser , there are two screws that require an Allen wrench to adjust- they are on top of the bow limbs, one on each side.- to be certain that the adjustments are the same on both sides, tighten them down until they bottom out- then make one turn counter clockwise on both sides and check it - repeat until the bow is at the poundage that you want it to be- then you will need to check it for proper tuning- take a ruler and measure from the back of the bow limb where it meets the riser and go to the bow string- the distance should be the same on both limbs- if not adjust it on one side until both sides match up and are an even distance from the string to the backside of the limb where it joins the riser- good luck

Question Source